- - sewing machine;
- - needles;
- - thread;
- - pencil or soap;
- - pins;
- - thick thread or twine;
- - longest rail;
- - sartorial meter.
Spread bottom layer covers a large flat surface.As a tailor's table folding table can be used if you have it.More often have to deal with similar work just on the floor.The carpet or carpet is better to remove and clean the floor.Lower panel lay face down.
on the bottom panel gently lay the insulation.If you cut out the middle layer of a large sheet syntepon, hitching his dressmaker pins at the edges.Not necessarily shear around the perimeter, you can seal the corners and midpoints of the sides.Insulation of the pieces can be pre-sweep manually overlap.Seam can use any.
put a layer of insulation on the top panel facing up.Carefully align the edges.The preferred use for this purpose tailor meter.The fabric surface is also necessary to align as much as possible.
Find the center of covers.This can be done with thick thread or thin rope.Secure the end of the thread at the corner of a thick curtain and pull it diagonally, and then just pull the string on the other diagonal.In several places the Pin auxiliary thread.You can draw a soap or a pencil.Mark the point of intersection.Make a few stitches in the middle.They can then be removed, but you can leave, making the drawing element.
Then begins the actual stitch.It can be performed in different ways.The most common - on the diagonal, and horizontal and vertical straight lines.It is very suitable for monochromatic fabric or cloth with a small figure.First, baste the layers from the center along the diagonals.Then draw vertical and horizontal lines at a distance of 10-12 cm from each other.If you have a long flat rail, it's best to use it.Cleave edge covered dressmaker pins.Those pins that you fastened the lower and middle strata, can already get.
can go the other way.If the fabric with a very large geometric pattern, use it.Diagonal pi This quilt is still better, but no more lines can not draw.Just baste layers of the lines that are in the picture.Similarly, you can quilt and patchwork blanket.It is very important to get into the seam, which stitched rags.
Prepare the machine.If you have a foot for darning, put it in place of the primary.The foot can be simply removed.Adjust the tension of the upper and lower thread.As a rule, the stitches best suited minimal needle thread tension, but there are exceptions.Quilted scraps left after cutting.
Wrap the edges covered, leaving free only the central part of it.Edge Clip Available safety pins.Quilted bedspread for seasoned lines, gradually removing the pins and increasing the exposed surface.
cut the top and bottom covers must be made of cloth, which is already the village.The fabric can be ironed through damp rag, but better just to wash.
quilted bedspread can manually using the seam "forward needle".The stitches should be of medium size, and better covered quilt twice to line resembled a machine.