- - Tape;
- - scissors;
- - a piece of tissue or excess tape from which you can cut thin strips.
If you have an urgent need to issue a gift, and nothing but a piece of satin ribbon, you do not have have to confine ourselves to the classic bow.It may look nice, even if you make it, and the ends of the ribbon beautiful curly cut with scissors.Place ribbon satin side up in the middle of the upper surface of the box.Spend tape in the middle of the sides and bring the ends to the bottom side.Get tips for each other and pull tape , that it lies tightly.Atthe bottom you should have a cross.
Bring the ends of the ribbon on the other two sides of the box, and then - on top of its plane.Spend them at the already-stacked ribbon around the middle.The ends of the tape should embrace .Tie a single or double knot.
Bend the ends of the ribbon at a distance of 1/3 of the unit and then tie a single knot.Spread the bow and curly ribbon, trim the edges with scissors.If curved scissors not, use regular, cut the edge of the area and making a V-shaped notch.The ends of the rigid strip in this case can be spun repeatedly conducted thereon rings scissors.
If the tape is long, tie a double bow.Do all things in the same way as in the single tying a bow, just bend the ends vdvoer closer to the node.Tie the ends of the bent bundle, then the remaining pieces of tape again bend them in half and tie another knot.Dual ribbon to be smaller in size, but magnificent.
If you have a tight packing tape, you can tie a piece of ribbon bow terry roll into the ring.Make several of these coils by placing a ring on the ring and aligning the edges of the tape.Bow get the greater the wider the ring.
Squeeze the ring to get a flat multi-layer tape.The fold can not wipe out.Cut the corners of the strip until the middle of the short side of the tape.Incisions should be on one of the long sides.
Spread the ring, then squeeze it into a strip by matching cuts.Bandage the cut area of thin ribbon, string or strips of cloth.Thumb and forefinger of one hand, hold the bow in place the resulting cuts.
your other hand gently straighten the ring, taking care not to tear the ribbon or string.Folded petals one by one.One tab is folded up, the other - down and twists them in the axis.
Pack the box.Just as in classical tying a bow, put tape in the middle of the top of the box, on the sides of the print down to the center of the box and make a cross over output ends up.Tie a double knot and trim the ends of the short.Attach the bow on the knot clip or glue.
terry bow must be 40-50 cm tape, in addition to that need for roping box.
- how to tie a box