Tip 1: How to carve out a women's shorts

Shorts - perfect outfit for the beach and for the office, you need only select the appropriate model and the fabric.Shorts will be able to carve out their own even a novice seamstress.
you need
  • - a large sheet of paper;
  • - Pattern-base classic trousers;
  • - pencil;
  • - line;
  • - scissors.
Guide
1
to build a pattern short, you need to create a pattern-base of classic women's trousers.Instructions on how to build it on http://www.kakprosto.ru/kak-91888-kak-postroit-vykroyku-klassicheskih-bryuk.Once it is ready, you can start modeling the future shortstop.
2
Measure the length of the product.It can range from the knee to mid-thigh.Lower waistline by 3-5 cm.
3
Mark the input line into the pocket on the front part.Draw a line diagonally, departing 3 cm from the sideline towards the middle and down 12-15 cm.
4
If you want your shorts were a little loose and flared, draw a straight line from the darts.Cut a piece of this line, and open, with a point on the waist line should
be combined.
5
Build detail of pocket bag.Attach a piece of paper and circle the item before the line the entrance to the pocket.Pull back on top of 2 cm per side, and from the bottom - in the direction of 6-7 cm and 2-3 cm downwards.These points are connected by a smooth line.
6
Make pattern belt and belt loops.Pattern belt loops is a rectangle 3x5 cm. Belt - a rectangle, the length equal to the circumference of the waist plus 6 cm and 6 cm wide. The width of the finished belt is 2 cm. If you want to carve out times greater, respectively, then increase the width of the part.It should be equal to the desired width of the belt multiplied by 2 plus 2 cm for seam allowance.
7
Paper Pattern shorts ready.Lay it on the wrong side of the fabric and draw chalk.All parts are cut, leaving a seam allowance of 1 cm on the side edges and waist line.For hem leave 3-4 cm. Details belts and belt loops cut out without allowances (they are embedded in the pattern itself).
8
pocket bag cut from lining fabric, and the side seam area above the entrance to the pocket - from the main.

Tip 2: How to build a pattern short shorts

considered the most summer clothes.They also in daily life convenient and comfortable home or, for example, sports training.However, their main purpose - summer clothes for different occasions.Women's shorts come in a variety of sizes and shapes - breeches below the knee, mini, free, form-fitting, classic denim.In order to stand out from the crowd is better to sew their own.
How to build a pattern of shorts
you need
  • graph paper to construct a pattern;line;pencil;scissors;pins;fabric - 1 m;elastic;interlining;zip-fastener (14 cm long);decorative buttons
Guide
1
Make a tape with the following measurements: length shorts;waist circumference;hip circumference;girth circumference at the site of the end of the leg length shorts.To construct a pattern short, you need to decide what kind of fabric will be made shorts and what model you prefer.After that, go to the construction of the pattern.
2
Build pants pattern desired model.Construction of the pattern of shorts made on the basis of the transformation of the pattern of trousers.And then on the basis of established patterns raschertite pattern shorts.To do this, draw a horizontal line across the length of the pattern trousers (the distance depends on the desired length shorts).After that cut the lower part of the pattern (through the final leg length), and attach a new piece of graph paper to create patterns tuck the edges under than the width should be slightly wider than the leg shorts produced through the final length.
3
Spend below the final three short-length parallel lines.One draw a distance of 4 cm from the line of finite length, second, departing 4 cm from the first line, and a third, departing at 2 cm from the second line.All excess paper below 3 lines cut.Then fold the pattern in the place where the three lines traced.Note the extension of the line from the edge of the main gateways to the short pattern.Again, cut all the excess paper along this line.
4
Transfer the finished pattern on the fabric, this paper apply directly to the pattern on the fabric and cut out all of its details on the fabric, adding 1 cm from each edge of the fabric in the seams.Then connect all the details of the stitches, while not touching gateways.Then prostrochite all connections on the edge of the machine and secure gateways, prostrachivaya through continuing joint that connects the parts shortstop.Then insert the zipper, stitch machine stitch from the wrong side and sew a button.
Sources:
  • Shorts for Summer
Sources:
  • pattern shorts female