Use the "American woman" - a method of treatment of narrow fabric, which is used in the processing of thin material.Remove the inside cut to 0.7-1 cm and defer to bending edge by 0.1-0.2 cm, then carefully cut with scissors to the seam allowance.Now tuck the edge of the half-finished another 0.2 cm and again defer to edge next to the line that you have done before.It should get a very thin slice processing is fixed by means of two lines.For flatness can be placed under the fabric while stitching a sheet of paper - it will reduce the slip, causing the line to get the maximum level.After completion of the work on the machine, carefully remove the paper from the seam.Typically, such a seam is treated bottom product.
Use the zigzag if you need to process the inner seams of the product.To this end, tuck the edge tissue inside about 1 cm, and then defer to the wrong side of the fold the smallest and most frequent zagzagom, then carefully cut the excess fabric close to the seam.Use only high quality threads, -0 if you manage to avoid many of the irregularities and other problems.As a result, after this type of treatment is to get a neat edge , perhaps somewhat wavy.If the edge will remain after stitching thread, then go over it with small scissors, cutting close to the line, try, however, it does not hurt himself seam.
Apply the combined version, if you do not fit any of the first two.To do this, first treat the seams on overlock narrow line in 2 mm, and then bend edge of the width of the resulting seam and defer to type again.The result is a neat smooth edge .To determine which method will suit you more than others, you can try each of the processing methods in action on a small piece of tissue.
Tip 2: How to process the edge
scarf scarf - an accessory that complements the image.Sew or tie it you can own, and processing edges depends primarily on the material of manufacture of the product.You can handle a sewing machine, or manually add the brush to the knitted scarf.
If the scarf is made of silk, its edge can be treated in several ways.The first method involves manual work - take the edge scarf , tuck it Rulik and needle and thread appropriate color attach to the wrong side of the product.Another option - the processing in the machine.Bend the allowance prostrochite underside and as close to the fold line.An extra piece of cloth, pushed to the allowance is cut.Then again, tuck and prostrochite again.The distance from the line to the edge of the product should be one to two millimeters.The new seam should be positioned slightly higher than the previous one.
If the scarf is made of viscose or other nesypuchego material, it is sufficient to handle a zigzag sewing machine.Double scarf can be treated as follows: Fold the right side facing the product, and then sew along the perimeter, leaving little space neproshitym.It is left to turn the product back on the front side.The remaining piece can be manually hem stitches invisibility.
very delicate fabrics such as chiffon, also handled a zigzag, it requires a suitable needle and the corresponding adjustment of the sewing machine.Furthermore, in some typewriters have overlock stitch, which is also suitable for such cases.
woolen scarf simply close the loop, and the edges can then start up pattern crocheted.Find the right accessory for your schema binding.Another treatment option - let the brush.To do this, take the yarn, fold the thread several times.The resulting beam bend in half and trim the edge of one , so that the thread dangling freely.Make marks on the scarf that between the brushes was the same distance.Pass to get the item in the hole in the yarn.The upper part of the beam is a loop of yarn.Pass this loop free edge - the brush is ready.
- treated as a professional