you need
  • -slomanny black umbrella;
  • -Short Black Lightning;
  • -kosaya inlay black;
  • -Black cloth on the hood;
  • -karton;
  • -ostry knife;
  • -vodoemulsionnaya paint;
  • -Black gouache;
  • -lak;
  • -vykroyka hood;
  • -belevaya gum;
  • -kley;
  • -shveynaya machine;
  • -nitki, needles, paints, brushes.
Guide
1
costume consists of two parts - a mask and cloak.We need more black trousers, but you are sure to find them at your local store or even in his closet.Cloak take an old black umbrella.Remove with a pen and needles.Cut the top of the umbrella.Holes are made so as to obtain a cut-out "on the neck."
2
Make an incision on the neck in length zipper.The head must move freely in the hole.Fold the edge
s of cut to 0, 5 cm. Baste the zipper and stitched.Treat neck piping.
3
Riding Hood sew the pattern at any hood.In addition, the store work clothes can find bonnet that workers put some specialties under the helmet.It must simply take in size.If the hand is nothing there, draw a pattern for yourself.Measure the head.You need two measurements - putting the head and the height from the shoulder to the top of the head.Draw a rectangle.Determine where it will be part of the front.Her leave as is.On the back of the upper part of the bevel angle arc.
4
carve out 2 parts of the hood.Put them face each other, and jotted razutyuzhte back seam.The rest of the hand bend on the wrong side twice and hem.It can be on the wrong side at the level of the throat to sew a strip of cloth and make kuliske for gum or drawstrings.But you can not do this because the bottom of the hood will be refueled at the neck of his cloak.
5
cut from cardboard mask.In principle, it is no different from any other wide carnival masks.Draw a straight line equal to the width of the forehead.Continue its edge further 8-19 cm. Divide the line in half and dip down perpendicular to a length equal to the height of the forehead, plus half of the nose.From the end of the initial straight, too, drop down a bit shorter perpendiculars middle.Connect the end of the perpendicular to the ends of the side.Mark the places for the eye, draw a horizontal oval.Cut out the mask.
6
Make your ears.It's just 2 long rhombus of the same board.Slightly bend them on the long diagonal.If the board is not very thick, make them double.
7
Twist mask tube so that it has acquired the right bend.To the sides of the glue or sew the ears.Attach the rubber band.It can be glued to the underside of the mask, and to strengthen the place of gluing cardboard circles or squares.You can use adhesive tape.Try a mask and adjust the size.
8
Prime the mask of latex paint.Cover it with black gouache, then varnished.Drying her best on the big bank that she kept bending.