you need
  • -kapronovye thread;
  • -shilo;
  • -metallizirovannaya thread;
  • -pintset and needle.
Guide
1
Use sturdy, thick thread, nylon suit.You will need an awl and a loop.Her fabricate themselves to do this, take an elastic steel wires with a diameter of 0.4 to 0.5 mm.Suffice it to two centimeters for the manufacture of metallic thread loops.Heat the midpoint of the string on the flame of a candle, and then fold it in half.
2
Now Make a loop handle, that would be convenient to pull the thread.Take the metal rod with a diameter of 8-10 mm and hold it in the middle of the ends of the string.For this you need a screw M5 - M6.Pre-drill holes for the thread.Now expand a little loop at the end of the thread held.Give eyelet in the form of a small hook.
3
and directly on the seam.Soccer balls are composed of pentagonal patterns, which have a ready thread holes.One side of the pentagon - one seam.To sew it take about fifty centimeters of the thread.The ball is stitched inner seams - threads must be inside.
4
First Adv torn seams and make sure that they are not further apart.The knot is usually located near the corner of the pentagon.If it is sold - tie it.Repeat two - three times.
5
Now this hole miss a loop.It must pass through both holes linkable pentagons.
6
end of the thread insert in the loop, and drag it through the hole.The ends of the filament should be equal.Then tie a double knot.Behind the knot, so that he was inside the ball.
7
Then insert the right side of the loop in the next two holes, and seam pull one end of the thread from left to right.Drag one end of the thread and insert the eyelet in the same two holes seam on the left, then pull the other end of the thread from right to left.
8
Then repeat the process.When you get to the corner of the pentagon tighten the thread by pulling both ends, and tie a knot in the four times.If the thread will remain for the next stitch - continue.If not - cut and start sewing again.The last suture do not tighten strongly, and push the knot wooden match into a ball.