Guide
1
Start filling the manual sewing machine with the upper thread.It is this thread that will run from the spool to the needle eyelet.Raise the presser foot, lifting it up for a special lever.Tweak the handwheel and set it in a way in which the take-up lever and the needle will be in the top.
2
Put coil on the bobbin core.Take the end of the thread and draw it through the slot of the upper thread guide toward the upper thread tension regulator.If the thread is not passed through the thread guide, the tension dial it hits the wrong angle, so be careful at this stage.
3
Skirting the tension dial from the bottom, lay a thread between two metal washers.Pull it up and set up the hook of the thread guide.And then pass into the loop of the compensation springs.
4
Pass the thread through the eye niteprityagevatelya lever and slide the hook, located on the front board.Pass the thread through the two lower thread guide.Insert the thread from niteprityagevatelya eye of a needle.Pull the thread to twenty centimeters.
5
Wind the bobbin thread and insert it into the bobbin case.Place the end of the thread under the tension spring so that there are still ten centimeters.Set the bobbin in the shuttle.Make sure that the lever of the cap was in the slot designed for it.If it is inserted correctly, you will hear a click.Close the valve.
6
Hold one hand end of the thread passed through the eye of a needle, turn the handwheel toward you so that the needle is lowered to the bottom and grabbed the thread extending from the bobbin case.Scroll wheel from him and return the needle to the highest position.Pull out the bobbin thread through the hole of the needle plate.The ends of the strands tuck under the foot and pull back.