How correctly to make the insertion of two flaps?The sections to be connected, unwinds 2-3 cm and tack to each other so as to match all the homogeneous part of the figure as the weft and warp.After processing, the front of the joint pass inside out.The thread on the wrong side weed out carefully so as not to pierce the face fabric.To joint was thick, the ends of the pull prodernutyh yarns while grasping two or three strand two arms at opposite sides.

Then moisten the remaining ends to the wrong side, you should try dishevel them so that they become st

rong fluffy.This ensures a uniform binding between two connecting flaps.Next, flatten the ends, cut off the excess.At the same time every two or three fingers grab the end of the left hand and pull them at the base.Strained cut the thread, trying to regain its usual position, the spring and delve a bit into the fabric, so that the seam flap is an almost imperceptible.The last step in this connection - by ironing a damp cloth.

If ironing should be careful, because in this final stage is very easy to ruin all the work done.Fabrics with the embossed pattern is moistened slightly and stroking little hot iron.Some fabrics with uneven chaotic movement of iron and wetlands pleats.This is the feature of fabrics containing polyester and nitrone.When working with them, you should try to move the iron in one direction.

With strong pressure on all iron heavy fabric (gabardine etc.) As a result of flattening in places weaving insert formed brilliant plots - lasy.On the reverse side to remove them necessarily, but from the front surface of the product lasy need to be addressed.This is achieved by stripping damp cotton cloth is not pressurized, and a slight touch of the iron.The quality of the work performed is checked by finger pressure.The renovated site should not be deformed more than the intact tissue products.