Use accurate drawings for the construction of parts and Hull.To get started on a plywood board wider than the body of 30 cm and a length greater than the height of the housing 40 cm raschertite the real size frames and bypass stem.
Spend on the upper ends of the horizontal line of the frames.Rascherchivaya patterns, consider the thickness of the strips of material and the inner skin boats.Fragments of the cross connect patterns using the lining of plywood centimeter thick.
Before assembling the fragments of a boat contemplate the most convenient way to set the outer casing.
Collect matrix boat so you get tough and rob
ust design, which is not deformed in the further construction and assembly of parts.
Tension along the boards installed in the bottom of the matrix body, steel wire, which will be guided in the construction of the vessel.
installation patterns start with midship bulkhead fixing part vertically and perpendicular to the line.
Install braces on the bars base boat.Then install all the patterns and start to sheathe the inside of the casing longitudinal rails 15 mm thick and 50 mm wide.
bottom inside sheathe strips width of 100 mm.Place one rail on the board, and the second on the bottom, and then install the rack in the upper edges of the sides.
inner surface of the body after the installation of all the elements of the drawing obsheyte trehmillimetrovoy plywood or hardboard, gluing sheathing material with glue and epoxy putty zashpaklevyvaya gap.Quality putty should be high - as much as possible align the plywood surface, grind and paint it with two layers of waterproof paint.
Once dry, apply the surface of her wax or petroleum jelly, and then attach it to the final and fiberglass outer skin (laminate or fiberglass).Your boat will have a three-layer lining.
To complete the deck of a light material, use a thick and light foam.Using drawings, fabricate the upper deck and cabin of the captain.
If the work will lead a few people, you can make the boat fast enough to save more money for its purchase.