you need
  • - a sock with a hole;
  • - sock yarn in tone;
  • - needle;
  • - scissors;
  • - darning egg (fungus).
Guide
1
Instead fungus (eggs) can be used to patch up any solid with a round object such as a bottle, a wooden egg or a light bulb.Place the hole over the darning mushroom and cut all loose threads sticking out of yarn.Properly tighten the damaged material on the fungus.Now take a long strand of yarn and thread the needle.
2
create the basis for a patch.Follow the stitches around the outside of the square hole by threading the needle through the four tabs away from the edge of the hole and continuing chain of stitches on all four sides, secure.
3
Then start from top to stretch across the entire area of ​​the guide hole horizontal line of yarn from side to side.Place the thread tightly in row
s at the same time pulling the edges a bit.Horizontal threads can take back to the 3 deep stitches with intact surface of the sock.
4
yarn end must be in the lower right corner and continue your way to the top right corner of the darning area.Therefore, a thread with a needle held in a vertical direction through the horizontal rows strung up and duplicate stitch over the existing (intact) loop.
5
further, reaching the hole, use the earliest by horizontal guide lines.In the horizontal direction, pull the thread through the taut line and needle thread held under the nearest vertical row, returning back, walk the needle through the last loop and bring it under the working thread.
6
Note that when moving from top to bottom, creating a loop, you need to take the needle under the next guide line.In this direction, the vertical column of walk with stitches to the lower part of the square and make a 3-stitch loop on the whole loops on the edge of the hole.
7
Then again, a needle and thread through the guide lines perform to the top of the square.And since the top of the square make a stitch, working with the second string.
8
proshtopayte In this sequence the entire surface of the damaged area on the toe.As a result, you should get a very smooth, and pretty darn accurate.
9
This method is similar to the Swiss (V-shaped) darning with some modifications.Loops Swiss darning performed starting from the bottom of the hole, and here - from the top down using guide (horizontal) yarns.