Guide
1
starting to sew, always lower the presser foot and the needle, and only then take place.Turn the handwheel only towards themselves and learn how to install the machine in needle and thread to fill.Regularly lubricate the machine, no matter how often it is operated, and watch over the purity of the mechanism.
2
For lubricating the machine use a special oil for domestic sewing machines.Regularly clean the shuttle car.Learn the different types of joints that can be performed on the machine, and apply them to the tissues for which they are intended.
3
To prepare the machine treadle to work, fold the cover of the machine, set the head on the hinge
joints and fix screws.Canopy attach to the platform with screws and washers, and then close the valve and lower the valve on the machine head.
4
strap pass through hole visor and support bar, connect it to a clip and fill in the flywheel and drive wheel.Switch the machine to idle by turning the screw on the friction, and provide a flywheel in motion by pressing the pedal.In order to switch the machine back on the stroke, turn the friction screw myself.
5
For qualitative and effective work to properly prepare the car in the process of sewing.To do this, take-up lever to its highest position by turning the flywheel, and insert the needle in the needle holder until it stops, making sure that the flat side of the needle pointing towards the foot rod.
6
Tighten the needle screw.Place the take-up lever to its highest position, raise the presser foot and remove the spool pin until it stops.Set on a spool of thread.Correctly thread the string - from the spool through the thread guide, slide it between the washer controls the upper thread tension, thread the take-up in the hole, and then the thread guide on the machine head and the needle holder.
7
Thread the eye of the needle.Now thread the bottom thread - open lower compartment, remove the bobbin from the bobbin case and wind the bobbin thread.Insert the spool back into the cap, pull the thread through the slot, and insert the cap into place.Turn the handwheel toward you to pull up the bobbin thread.Both thread tuck under the foot - you can now sew, holding and guiding the fabric.