- - thread the desired number;
- - manual sewing machine.
Pick the necessary color thread.Remember that the bobbin thread should be in the top 1 room thinner or, in extreme cases, of the same thickness.
Open the sliding plate on the machine and remove the bobbin case from the hook.Remove the spool cap .Sometimes a new bobbin may not be suitable to the existing cap.Check that it is inserted into the cap.In no case do not try to force her to push.This can lead to damage of the spring on the bobbin case.
Winder can be located in different parts of the machine, depending on the model, but the principle of winding the bobbin does not change.Put flywheel sewing machine to idle (main shaft is disconnected from the flywheel) - the needle remains stationary during rotation of the flywheel.Put bobbin winder on the rod so that the key on the shaft fits into the notch in the bobbin.
Place the spool of thread on the spool pin.Threads with coil thread the tension between the washers.This thread should be coming from the tensioner to cross the one that goes from the coil.The end of the strings a few turns on the fasten thread the bobbin and through the hole in the upper disk.Bring up the bobbin winder with special emphasis.
few movements of the flywheel make sure the spool spins in the correct direction, and the thread is wound.After the wire winding, a flywheel rotating by the actuator.
Follow spool of thread or gently hold her hand becausewith the rapid rotation of the coil may slip off the bar.Winder stop (otschelknetsya) when fully wound bobbin.However, you can stop the winding as soon as you feel the bobbin thread is enough.Remember to perform a single line optionally wound bobbin completely.
Take reel from the stop and remove the bobbin .Restore stroke machines.
When threading and winding the bobbin thread, it is advisable to check with the pictures placed in the operating manual of your vehicle.