Guide
1
Get a sufficient amount of bias binding or make it yourself.To do this, cut on the bias tape long 3-4 cm wide, Sew them by putting slices diagonally, straighten the edge in different directions.Mark the middle of the entire length, fold and otutyuzhte.
2
retreat from one end of the bias binding 0.5-1 cm, fold it inwards otutyuzhte.This region will begin.
3
Place oblique Bakey on the back side of the product to be processed, so that its front side is adjacent to the wrong side of the fabric.Align the edge of the neck with a bent end Bakey.Route basting stitch along the entire length of the treated area.The edges of the product on the shoulder seams must be spread in different directions.When the neck will remain until the end of 2-3 cm, cut inlay with a margin of 0.5-1
cm, fold the remainder inside, finish basting, fasten thread.
4
Remove Bakey, to be located overlapping with respect to the front side of the product.
5
Fold about 0.5-1 cm long cut from the inlay inside, route Basting seam on the front side.Try to keep the belt width on both sides was the same, it's easier for you to work on the sewing machine, and the product will look neater.
6
Use a sewing machine.The face of the basting seam route the usual line.Hide the ends.Remove basting.
7
Carefully sew both sides of the fold bias binding on both sides of the neck.If the wrong side line did not pass on the edge of the tape, it will catch a few stitches.If the machine seam gone too deep inside, and the edge Bakey can unbend and expose slice unpicked better detail and do everything over again, as gently mask error with a conventional needle out.
8
If you use a high-quality oblique Bakey with ironed creases, you can immediately put it on the neck so that it covers the edge of the product, and pave a basting stitch from the right side, and then duplicate it on a typewriter.