Guide
1
Take a measuring cup, a fork, a plastic container, as well as the form for molding, which is suitable as a simple bowl.If you purchased a set for snapshots, you'll find it in a bag 3D-gel.Pour into bowl 100 grams zagotovte and 160 ml of warm water.The colder the water will be for breeding gel - the slower it will harden.
2
Wait until the child falls asleep to impression taking procedure is not scared and worried it into powder and pour prepared water.Stir the mixture with a fork until you have a smooth consistency without lumps.Take the edge of the bowl and tap the bottom of the hard surface of a table or chair
.
3
This will get rid of air bubbles in the solution.While the gel is not frozen, dip it in the open palm of the child, and then the foot of his legs.After some time the gel will harden.
4
Setting time depends on how warm or cold the water was, where you planted it.After solidification of the gel, carefully remove the molds from the arms and legs of the baby.
5
in a small plastic container dissolve in water gypsum powder and stir with a fork.Ingredients must acquire the consistency of liquid sour cream and not have lumps.The silicone mold from the solidified gel gently pour the plaster solution.
6
gently tapping the bottom of the molds on the table to expel air bubbles.Pour thus two forms, and wait for 30-40 minutes until complete solidification of gypsum.You can check the degree of hardening plaster hand - in the process of solidification of gypsum is heated.
7
Turn the tins upside down and remove them from your casts .In order for them to become more neat appearance, sand the bumps and roughness with fine sandpaper, then polish the figures and whisk the dust cloth or brush.
8
Ready molds can be covered with lacquer, glue on the superglue to the base and place it in the frame.