Tip 1: How to icon

Make icon can be of any material for creativity.Suitable for felting wool, wood, plastics, ceramics, and other people's articles (for example, finished articles made of these materials).The icon can be done even from the beads.Here your imagination is unlimited.Safety pins may be purchased for cutting and sewing.
you need
  • safety pin for badge, plastic red and black colors, tools for working with plastic or clay, silver acrylic paint
Guide
1
icon in the shape of a flower poppy.Mash a small piece of red plastic in your hands until it becomes warm.Roll it into a thin pancake.You can use a pen or a special rolling pin for plastic.
2
Form poppy petals by cutting them with a knife or cutter (you can also just break stuff).Leave them connected in the middle.Smooth out the edges to make them smooth.Remember: poppy petals are very thin, so often their edges to form a beautiful wave, try to repeat it.
3
Take 2 small pieces of black plastic.Mash and roll them out 2 circles, one lar
ger than the other.Take a knife and make a lot of cuts coming from the circumference to the center.The distance between the notches should be small in order to obtain a thin fringe.Insert the smaller to the larger circle, and then attach them to the center of the flower.
4
Attach a safety pin on the other side of the poppy.Put the finished product on a baking sheet.It is better to put between them a piece of baking paper or foil, as the plastic may leave marks.Bake at 130 degrees in the oven for 30 minutes.

Tip 2: How to make your own hands icons

As in previous years, icons are quite popular youth attribute symbols.On the icons depict famous rock musicians, provocative symbols and written appeals to all sorts of activities.We'll show you how to make your icon hands .
How to make your own hands icons
you need
  • Metal sunset icon diameter 35-56mm, scissors, picture-picture for the new icon with margins of at least 1.5 cm to the hem.
Guide
1
consider several options for self-production of icons.
Option One - alteration finished the setting icon.Sunset icon - a metal or plastic round icon with a pin on the back side.Please separate icon on the plastic substrate.
2
Then remove the metal part with the image in the film, taking care not to damage it.Next, remove the image and film, tilting edge.Then attach the desired picture image to the base metal icon, bending field basis.
3
Top attach film as bending edge inwards.At the end of the prepared insert metal part icon plastic base with a pin.Icon is ready.
4
Option Two - completion of the setting icon.This method is much easier to above.For the manufacture of an icon need sunset icon with a pin, a new image for the icon, made in the self-adhesive paper, a scotch.
5
Type the desired image on the self-adhesive paper, stick it on the icon.Secure the top wide adhesive tape so that no more bubbles and wrinkles.Smooth sharp object is not the final image.Instead of scotch image can be laminate, using iron and plastic bag.
6
Using the same technique, you can make the icon in the form of the bouquet of flowers.You will need tissue paper or thin fabric glue.
7
Cut paper sexfoil or twist of pieces of colored paper flowers freeform.Adhesive glue them to the base with a pin.Allow the glue to dry.After a few hours of costume jewelery ready.
Note
Check out what material is made for a safety pin icon.If it is a metal with a low melting point or plastic, the pin should not be baked in an oven together with the product.After cooling, the product is better sticking to it the pin with glue or varnish.
Helpful Hint
For the first experiments with plastic is better to buy cheaper, but less quality.There are domestic plastic submitted in only one color - terracotta.There is also a good Polish plastic.Remember, cheap plastic - more brittle, so too thin parts of it will not receive.It also heats up slowly and for a long time resisted attempts to stretch it.