Tip 1: How to make a spaceship model

Kids love to build different models of fancy military technology: missiles, ships, tanks.To take them in a matter of time necessary, offer to make the layout of the space ship , using the easiest material to work with.Performing work can show your friends, as well as to present as a gift.
you need
  • Colored paper, sheets of cardboard, scissors, pencil, ruler, glue.
Guide
1
Put in front of cardboard, determined with a high launch and cut a rectangle, which is then roll tube.
2
Glue glue the resulting body.
3
On a separate sheet of paper prepare a template for cutting the "fins" of the rocket.
4
the bottom of the rocket make 3 slots and paste produced "fins".
5
Cut out the circle and fold it cone.Glue the edges.
6
Cone put on top of the case and secure.
7
Cut out of colored paper and glue on the decorations already prepared the layout of space ship .

Tip 2: How to make a model of the spacecraft

Today's children almost lost interest in s
pace issues.To revive the children's interest in space is possible by building together with them in the classroom work spaceship model, similar to those built in the childhood of their fathers.
How to make a model of a spacecraft
Guide
1
main part is the layout of the spacecraft cylinder.Apply it in a cardboard bank of Pringles potato chips or other in the same package.Thoroughly clean it from the residues of food.Using spray paint the jar in silver, then dry.The color of the balloon was performed with a distance of about half a meter, otherwise the paint will dry out for a long time.Do not use with the open fire.
2
Make a simulation of solar panels.To do this, take two thin boxes of CDs.Two sheets of paper cut to the size of the boxes, soak in blue ink - they are well mimic the color of these solar panels.Put them in a box.To the cylinder until the last crepe.
3
Take modeling knife.Cut the cylinder several windows.Inside tighten film cut from a plastic bottle.If you wish, you can use colored bottles.Exterior paint around the windows on top of a silver permanent marker ink circular frame with screws - they can simulate a simple point.
4
These spacecraft during the flight do not blink.But the layout will look much better if you give him this power.Get ready flashing block of broken toys and place inside the cylinder, make holes for the LEDs.Redo it is powered by AA batteries or external power to the same voltage as the original.Observe the polarity.If batteries are used, add the switch and put it on the cover.
5
Take two or three plastic spoons and cut them to handle.It will be parabolic antenna.Attach them to the ship by means of staples.And some of them do holders converters.Sami converters imitate small caps on pens.Place them in the same way as this dish, which today are on every home.
6
Make a stand for the model.Place on it the cylinder vertically.Then secure it with the help of parts and screws with nuts solar panels.The model is ready.
Sources:
  • how to build a spaceship
Note
Wait until the glue dries on the body before prodelyvat slits for the "fins".Themselves "fins" missiles worth doing from a dense cardboard, perhaps even double-layer to the missile could stand on the surface and does not overwhelm.
Helpful Hint
held tightly to the cone, use scotch tape or fasten inside staples.
Sources:
  • site where you can see the types of performance craft with their own hands.
  • space layouts