you need
  • - hook;
  • - thread.
Guide
1
Perform chain stitches required length.You should end up with so much polustolbikov nakida , as you typed links, plus a couple of loops.
2
Count third loop from the hook (some knitters fourth count) and knit in her first polustolbik with nakida .To do this, you must first throw the thread on the rod of the working tool and hold it with your finger to nakida does not come loose.
3
Enter the shank of the hook into the loop and again throw with thread;drag it through the handle of the loop.
4
Throw working yarn again and now pull it through both
loops at once and nakida located on the hook.
Before you - the first lasting column.
5
Make nakida;enter hook in the next st air circuit;pull the thread through it and make a new polustolbik with nakida described above.Just keep working until the end of the series.
6
not tighten thread working too hard, otherwise it will be difficult to introduce the hook in tight loops.It is recommended that the last loop on the hook with a large bow;provyazyvaniya after next, gently pull the handle of an enlarged to the desired size.In this case, the knitted fabric is a more lightweight and flexible.
7
Vyvyazhite at the end of the first series of strong pillars couple stitches.They will be "stepping stone" to the next row;while the lifting eyes are equal to the first number of the pillar lasting.
8
Work invert.Vyvyazyvayut polustolbik without nakida from the second loop of the previous row;Work on the model.