you need
  • - glass of 2 mm thickness and dimensions of 120x80 cm;
  • - Aluminum profile 20x10 mm rectangular section;
  • - tube made of aluminum or steel, 10 mm in diameter;
  • - Furniture wheels - 4 pcs .;
  • - 30 mm bolts with lock nuts;
  • - tap threaded 4 mm;
  • - white oil paint;
  • - wrench.
Guide
1
Take aluminum profile and use the grinder and sawing metal saw off two identical segments of length 50 cm, 100 cm and 122 cm.
2
Tomake details of the segments 50 cm long, take a power drill to drill for metal 4 mm diameter and make sure the center of the through-holes at a distance of 10 mm from each other.With the same hand, departing at 1 cm from the ends, drill one layer profile for mounting of furniture casters.
3
Perform installation of furniture casters.To do this, insert them into the prepared hole
s at the ends and with a key to screw the ends of the fastening screws, tighten them until they stop.Use locknut as a gasket.She did not give castors otkruchivatsya own.
4
Deal ends with a file, so they can not hurt or injure you during operation whiteboard.
5
To prepare the profile fixture on the end of the profile length of 100 cm make incisions depth of 10 mm using a grinder.Bend them so that they became cross-section profile.Using an electric drill diameter and 4 mm in folded petals drill two holes at a distance of 1 cm from each other.Cut a tap thread in these holes.You now have a profile fixture.
6
Drill two holes at levels 5, 50 cm from the profile of fastening and one hole at the end of the free end of the profile, stepping back from the edge of 1 -2 cm. Screw fasteners to profile the finished part with wheels.
7
Take a length of 122 cm, and at each end secure fastening profile.With the help of bolts to assemble the stand prototyping board.
8
Take a tube of aluminum or steel with a diameter of 10 mm and cut two pairs of sections 80 and 120 cm. With the help of grinders do a cross-section along the entire length of the tubes.At intervals, the length of 80 cm, exactly in the middle, drill-holes for fastening to the stand.Insert the bolts in them so that their hats were inside the tubes.
9
To make the canvas whiteboard, take a piece of ordinary glass and paint it with several layers of white paint (preferably from a spray), each time waiting for the drying of the previous layer.Insert the glass on a development stand, the unpainted side is the front and secure.