- - circular or straight needles;
- - auxiliary needle or petlederzhatel (pin);
- - yarn.
Tie sample knitted fabric 10 to 10 centimeters straight spokes or a test strip in a circular rows - this will be enough to evaluate the quality of their work and the density of knitting.To begin, enter the right needle movement to the left under the handle of the loop on the left spokes.You need to grab the thread (located behind the knitted fabric), and then a loop is drawn on the "face" of the work.Before you - the front crossed that some guidelines on knitting is alsocalled "the front loop of the lower lobe."
Place the thread before work and do the wrong a crossed loop.For this purpose a working borehole must log in textile shackle loop (located on the left spoke) movement to the right.The thread must be pulled to the wrong side of the knitted fabric.So often knit elastic sock to make it more elastic and did not wear out.
Try the front surface of a sample consisting entirely of crossed loops (for example, at the same sock).When stocking st round only perform facial 'tic'.When working on direct and inverse series in a number of purl loops do also crossed.Accordingly, purl crossed located above the facial crossed.
Master the simple relief patterns, which are based on knitting "cross" (crossing loops of thread handles).The manuals are sometimes required for knitting a crossing loop either to the right or to the left.Be careful, because the location of the crossing-dependent appearance of the whole face of the knitted fabric!
Practice doing cross-loop with different inclinations.This should be done in a personal series.If you provyazhete second loop of the first, the crossing will be on the left side;provyazyvaetsya when the second loop to the first, the slope turns right.Such a skill you will need to create the popular tows, braids, networks and other intricate decorative stitches.
When vyvyazyvanii Perekrestov of a pair of loops and more commonly used auxiliary needle.On her strung neprovyazannye loop, which will come into operation later.If an additional tool constantly falls out of thread handles, use a pin or a special petlederzhatel.This is especially useful when creating a pattern involved only two loops.