you need
  • - a sheet of paper;
  • - pencil;
  • - watercolor, gouache, pastel, etc. Etc .;
  • - bucket or a picture with his image.
Guide
1
Consider the bucket.Think of what it looks like most of all.Any object can be represented as a combination of geometric solids.The shape of the bucket is more reminiscent of a truncated cone, which lacks one of the bases.
2
Estimate the ratio of the height of the bucket, the radius of its bottom and top of the uncovered.If your figure is only the subject, place a sheet vertically.Spend a hard pencil thin vertical line so that it divided the list into two equa
l parts.
Estimate the ratio of the height and diameter of the base
3
Mark the height of the center line of the bucket points.In a swipe tag 2 horizontal lines.Put them on either side of the centerline approximate radius of the bottom and top edges.These points are connected in pairs.You now have a trapezoid.
Connect pairs of horizontal lines on the point
4
Look closely, the look of the bottom and top edge of the bucket.Present them on a plane.You will notice that the upper part is an oval.It is wider, the following with respect to the object to your eyes.Line connection bottom and side looks like an arc, the convex part of which is directed downwards.In the inverted bucket everything is the opposite - the bottom seems oval and visible part of the edge - arc.But in any case the curvature of the top and bottom lines will be approximately equal.
5
To draw a beautiful oval, put on the centerline of the place of its intersection with the edge of the same diameter small pieces up and down.Connect them to make ends meet diameter smooth curves so that the narrow portion of the oval does not get too sharp.Try to maintain symmetry.
Draw an oval upper edge
6
Draw an arc indicating a line connection to the bottom of the side surface.To make it more precisely, it is possible to draw an oval and bottom, just as you depicted upper edge.Just mark the invisible part of a thin pencil.
7
Mark the position of the handle.It is attached to the "lugs" on the top of the bucket.Pay attention to how many "ears" can be seen.If there are two, they are located on the sides strictly.One can be in any place.Pen is an arc.When you can see both attachment points, and the handle is lifted itself up, it looks like a smooth and symmetrical arc, the convex part of which is located on the center line.In any other position, the curvature of this part of your "nature" depends on the angle at which you look at it.Circle the pen with a double line.
Determine the position of the handle
8
time has come to transfer the amount of the bucket.See how the light falls on it.It has the meaning and the material from which to make your object.If a metal bucket and a shiny look, which is the brightest spot.Apply it on the circuit pattern.
9
Apply shading.Pencil strokes can go in two directions - from the bottom to the top edge of the visible line or parallel to the floor.In the first case, the bottom of the bucket line ends almost touching each other, and above - differ.In the second case, the strokes are parallel to the lower arch.Below are tight.As we approach the upper edge of the line are becoming more rare.Do not forget that you need to leave a bright spot light.