- cardboard, paper, drawing accessories, crayons, markers, paint, glue PVA
first determine so what model and what you arewill do.If you are new to the simulation, you should not choose a complex model with lots of detail.For the first experience of perfect thick paper or cardboard.It is also possible to use plastic or wood in the presence of experience with these materials.
Make a sketch on paper of your future model.Try not to forget anything, but do not overload the model with unnecessary details, which would complicate its assembly.Once you have made a sketch, you can start making detailed drawings.It is desirable that the entire body of the model was made from a single piece of cardboard or paper, but if this option is difficult to do, fabricate parts separately.In the process of drawing you will have a lot of extra lines.To avoid confusion, circle line, which will need to cut red pencil or felt-tip pen.
You can now carving blanks on your drawing.If there is no certainty that everything is done correctly, you can first make a blank of soft paper and try to get it to check whether all you have calculated correctly.The final blank crashed very carefully.Not bend in both directions paperboard fold lines, since its thin top layer may burst.Make a fitting piece.If everything is perfect for each other, begin the assembly model.This is best suited PVA glue, as it dries to not leave yellow spots, as is the case of the paper glue.Gluing should be most carefully, removing any excess glue.
Fabricate all the individual parts of your future model.Along with the main blank set them aside and let the glue sets.Once the glue is dry, assemble the model completely.Once again, set it out to dry.Think about the appearance of your product.For decoration you can use paint, crayons, markers, stickers.It all depends on your imagination.After drying decorate modelku.You can also make it to the stand.
gently work with glue, so as not to ruin the workpiece.Carefully check the correct execution of your drawing.It determines the appearance of your model.